Mazda Protege

Excessive heat can cause resins in your brake pad to vaporize or "outgas." As the brake pad wears, the used friction material turns into a fine dust. This boundary layer of heat, gas and dust builds up between the pad and rotor surfaces and inhibits performance. Here's where Power Slot's slotted brake rotors make a big difference.

Slots are machined into the rotor and help evacuate gasses and dust, shed heat, and keep the brake pad surface clean. And in wet, raining conditions, our slots helps push water off the braking surface for better stopping power.

The slot is machined to the rotor’s minimum thickness where it crosses the outside edge. If you cannot see the slot along the outside edge, the rotor has worn down to its discard depth.

This Part Fits:

This Part Fits:

This Part Fits:

This Part Fits:

This Part Fits:

With great looks and performance to back them up, the Mazdaspeed Protegé is a sport compact enthusiasts dream come true. Forge Motorsport have manufactured a valve that helps keep that dream in reality. The MSP01 is a unique twin piston blow-off valve that replaces the OEM piece. The 2 stage design allows the car to operate normally without worry of stalling, poor idle or check engine lights. Under boost the valve has a clean crisp sound that will definitely get you noticed. Aside from the head turning "Swoooooosh" the MSP01 looks as good as it sounds.

Machined from Billet aluminum the MSP01 is completely tunable and serviceable to keep up with your modifications as they progress. Installation is simple and takes less than 10 minutes. The MSP01 comes with Forge’s "No Hassle" limited warrantee and is available with your choice of two great finishes.

All Forge Motorsport Dual-Piston Atmospheric Valves have been designed and built with the intent of venting 100% of the residual charge air remaining in your forced induction system to the atmosphere at throttle lift. While we have incorporated many elements into the design of the Dual-Piston valves to aid in their compatibility with mass air-flow sensor equipped vehicles, we cannot always guarantee that each individual’s application will be compatible with a valve that vents the charge air into the atmosphere.

Forge Motorsport nor any of it’s Authorised Distributors can assume any responsibility for any adverse effects resulting from the installation of this valve onto a vehicle whose engine-management-system, whether factory or aftermarket, is not capable of compensating for the loss of metered air through a vent-to-atmosphere valve such as this.

This Part Fits:

This Part Fits:

This Part Fits:

This Part Fits:

This Part Fits:

This Part Fits:

This Part Fits:

This is a pre-owned ECU from a MazdaSpeed Protege.

This is our heavy duty 2.5" stainless steel downpipe from our SpeedCircuit Turbo kit for the Mazda Protege.

NOTE: THIS DOWNPIPE WILL NOT FIT A STOCK MAZDASPEED PROTEGE TURBO KIT.  It will not fit a Mazdaspeed Protege Turbo / T25 flanged turbos.  This is made to bolt up to a Ford style 5 bolt discharge.  If you are not sure what you have, this probably will not fit!

• TIG-welded construction
• Heavy duty and built to last
• Heavy duty and built to last
• Stainless flanges unlike other downpipes that use mild steel flanges that will rust and break
• Dump tube for an external wastegate that routes back into the downpipe. Includes a flexible section in the tube.
• Includes flexible section towards rear of the pipe
• Includes two O2 bungs - one for your primary O2 sensor and one for an optional wideband sensor.
• Designed for optimal flow supporting 400hp

Shipped without a flange on the inlet of the wastegate dump tube, so it can be used with various different setups.

This Part Fits:

This Part Fits: